Category: Blog

Franklin Miller vs Smith & Loveless Grit Removal Equipment Introduction Inorganic solids cause expensive damage downstream of the headworks. Eroded impellers, reduced digester capacity and abrasive wear on dewatering equipment cost utilities significant money in preventable maintenance. Yet headworks design frequently suffers from copy-paste specifications that ignore the hydraulic profile and grit characteristics of the […]

Top 10 Process Equipment Manufacturers for Water and Wastewater Introduction In the ecosystem of municipal and industrial treatment facilities, pumps, pipes and valves dominate the initial design conversation. But operational success frequently hinges on the specialized process equipment supporting the main treatment train. Engineers searching for the top general process equipment OEMs are looking past […]

JWC Environmental vs Franklin Miller Grit Removal Equipment Introduction Protection of downstream process equipment — pumps, valves, centrifuges and digesters — starts at the headworks. Improper solids reduction or inefficient separation leads to pump cavitation, seal failures and rag accumulation in digesters that necessitates expensive cleanouts. When specifying solids reduction technology, the industry frequently compares […]

JWC Environmental vs HUBER Grit Equipment: Comparison & Best Fit INTRODUCTION Grit accumulation remains one of the most pervasive silent failures in municipal wastewater treatment. Headworks screens provide visible capture, but grit often bypasses preliminary treatment, settling in aeration basins, consuming digester capacity and causing premature abrasion failure in downstream pumps. Selecting grit removal technology […]

Franklin Miller vs Hydro International Grit Equipment: Comparison & Best Fit Introduction Inorganic solids accumulating in downstream processes is among the most persistent operating burdens in wastewater treatment. Grit settles in aeration basins, consumes digester volume, and abrades pumps and dewatering equipment. Headworks design is the first line of defense, and two names that frequently […]

Top 10 Instrumentation Manufacturers for Water and Wastewater Introduction In municipal and industrial water treatment, data integrity is the bedrock of process control. Nuisance alarms are a persistent drain on operator attention at most plants, and a substantial share trace not to process failures but to instrumentation drift, fouling, or improper specification. The cost of […]

Introduction The movement of dewatered biosolids, screenings, and grit is often the final bottleneck in modern treatment facilities. While headworks and biological processes receive significant engineering attention, the conveyance of “cake” solids remains a frequent source of operational headaches, from housekeeping nightmares to complete mechanical failures. Engineers tasked with facility upgrades often face a critical […]

Introduction One of the most frequent oversight areas in wastewater treatment plant (WWTP) design is the “last mile” of the solids handling process: moving dewatered cake from the centrifuge, belt press, or screw press to its final load-out point. Engineers often spend months optimizing the dewatering device itself, only to treat the conveyance system as […]

Choosing a wastewater management approach is one of the largest and longest-lived decisions a municipality makes. The treatment technology itself is only part of it: the choice binds the community to a set of operating skills, an energy bill, a staffing model, and a permit compliance burden for thirty years or more. This guide works […]

Introduction Grit removal represents one of the most abrasive and maintenance-intensive unit processes in municipal wastewater treatment. Engineers and plant superintendents frequently grapple with a reliability paradox: while grit capture technologies have advanced significantly, the pumps tasked with transporting that captured slurry to classifiers often remain the weakest link. A single failure in the grit […]