Tag: treatment

Introduction to Submersible Pump Specification in Municipal and Industrial Systems The submersible solids-handling pump represents the backbone of modern municipal wastewater collection systems, storm water management, and industrial effluent transport. Unlike dry-pit configurations where the prime mover is separated from the hydraulic fluid, the submersible pump integrates the motor and hydraulic end into a single, […]

Introduction Dissolved Air Flotation (DAF) is frequently the unit process of choice when dealing with low-density solids, algae, or fats, oils, and grease (FOG)—contaminants that defy gravity settling. However, a surprising number of DAF installations fail to meet performance guarantees not because the tank is the wrong size, but because the whitewater system is improperly […]

1. INTRODUCTION Screening equipment constitutes the first unit operation in the preliminary treatment phase of municipal and industrial wastewater treatment plants (WWTPs). Positioned at the headworks, these systems are critical for the physical removal of gross solids, rags, plastics, and inorganic debris from the influent stream. The primary engineering objective of screening is the protection […]

1. Introduction In the landscape of municipal and industrial water and wastewater treatment, the handling of abrasive fluids presents a distinct engineering challenge that diverges significantly from the transport of clear water or non-abrasive sludge. While standard non-clog centrifugal pumps are the workhorses of sewage conveyance, they are frequently ill-equipped to handle fluids with high […]

1. Introduction In the context of municipal water and wastewater treatment, energy consumption represents one of the largest operational expenditures (OPEX) for utilities. Within these facilities, rotating equipment—specifically pumps, blowers, compressors, and mixers—accounts for the vast majority of this energy usage. The primary mechanism for controlling this equipment, optimizing energy efficiency, and managing process variables […]

Introduction In the realm of municipal and industrial wastewater treatment, sludge management typically accounts for 30% to 50% of a plant’s total operating costs. The efficacy of the dewatering process is the linchpin of this economic equation. While centrifuges and screw presses have gained market share in recent decades, the belt filter press (BFP) remains […]

INTRODUCTION In the design of high-head municipal pump stations and critical transmission mains, the selection of isolation and pump control valves is a decision that dictates facility reliability for decades. Engineers frequently default to standard butterfly or gate valves to save on capital expenditure, only to face catastrophic surge events, premature seat failure, or excessive […]

Introduction In the hydraulic architecture of municipal and industrial water and wastewater systems, the plug valve occupies a critical niche, balancing the requirements of reliable isolation with the capability for throttling flow control. Unlike gate valves, which are strictly for on/off service, or butterfly valves, which may struggle with heavy solids, the plug valve—specifically the […]

Introduction In the municipal water and wastewater sector, the failure of a critical valve actuator is rarely a minor inconvenience; it is often a precursor to permit violations, process upsets, or catastrophic flooding. For decades, design engineers and plant superintendents have faced a polarized choice when specifying electric actuation: adhere to traditional domestic manufacturing philosophies […]

Introduction The Archimedes screw pump remains one of the oldest yet most efficient mechanisms for lifting water and wastewater. Despite the prevalence of centrifugal and submersible pump technologies, the screw pump maintains a critical position in municipal and industrial treatment plants, particularly in headworks (inlet lift stations), stormwater pumping stations, and return activated sludge (RAS) […]