Tag: water treatment
1. Introduction In the municipal water and wastewater sector, the “nervous system” of any treatment facility or distribution network is its automation system. While Programmable Logic Controllers (PLCs) and HMI software provide the raw computing power and visualization, the successful implementation of these technologies relies heavily on the Systems Integrator (SI) or the Automation System […]
1) INTRODUCTION A staggering 60% of pump failures in municipal and industrial wastewater facilities are attributed not to mechanical defects, but to misapplication—selecting the wrong technology for the hydraulic and rheological conditions. Engineers frequently face a critical decision point when designing chemical feed systems, sludge transfer lines, or difficult process fluid loops: should they specify […]
Introduction In the hierarchy of treatment plant equipment, flow control gates are often treated as static commodities rather than dynamic machinery. This is a critical error. While a pump failure may stop flow, a gate failure can result in catastrophic flooding, bypass events, regulatory fines, and process upsets that compromise the entire plant. A surprising […]
Introduction For municipal and industrial treatment plant engineers, sludge handling often represents the single largest line item in the operational budget. With biosolids disposal costs frequently accounting for 30% to 50% of a facility’s total operating expenses, the efficiency of the dewatering process is not merely a technical detail—it is a critical financial lever. A […]
Introduction For municipal and industrial engineers, the centrifugal pump is the heartbeat of water conveyance and treatment infrastructure. However, a staggering number of pump installations fail to meet their expected lifecycle due to specification errors rather than manufacturing defects. Industry statistics suggest that over 60% of pump failures are attributed to operating outside the Preferred […]
INTRODUCTION In municipal and industrial wastewater treatment, the sludge dewatering process represents one of the highest operational expenditures (OPEX) outside of aeration. Engineers often focus heavily on the selection of the dewatering unit itself—the centrifuge, belt filter press, or screw press—while treating the feed and conveyance pumps as ancillary components. However, data from utility asset […]
Introduction One of the most persistent inefficiencies in modern wastewater treatment plants is the misapplication of mixing energy. While aeration systems typically consume the lion’s share of plant power, submersible mixers often operate continuously in anoxic zones, sludge holding tanks, and equalization basins, accumulating massive lifecycle costs. A surprising industry statistic suggests that up to […]
Introduction One of the most precarious scenarios for any municipal wastewater utility is the flooding of a dry pit pump station. In traditional designs utilizing standard TEFC (Totally Enclosed Fan Cooled) motors, a line break or seal failure that floods the dry well usually results in catastrophic motor failure, lengthy downtime, and expensive rewind or […]
Introduction to Double Disc Technology in Wastewater One of the most persistent challenges in municipal and industrial wastewater treatment is the reliable handling of thixotropic, abrasive, and rag-laden fluids. Engineers frequently grapple with the premature failure of progressive cavity (PC) pump stators or the ragging of centrifugal impellers in grit and scum applications. While many […]
Introduction In the hierarchy of municipal and industrial fluid control, the ball valve occupies a critical position defined by its low head loss characteristics, tight shutoff capabilities, and versatility across a wide range of diameters. For consulting engineers, plant superintendents, and utility decision-makers, the selection of Original Equipment Manufacturers (OEMs) for ball valves is not […]